Hey folks,
I'm using AT&T U-Verse, and I have the 2-Wire 3600HGV router/access point/firewall/switch device. I'm interested in setting up my IPv4 network to use both IPv4 and IPv6.
Right now, besides the 2-Wire device, I have a Linksys WRT54GL v1.1 running vanilla Tomato v1.28, and it's configured as the "DMZPlus mode" device in the 2-Wire. So, that's my actual router / NAT device.
I also have an Asus RT-16N running DD-WRT v24-sp2 (08/07/10) mini, which I'm using solely as an Access Point, but I would be interested in using it as an IPv6 router, if it works better than the Linksys WRT54GL v1.1.
Any ideas on where to get started? I have lots of questions:
Does AT&T issue IPv6 addresses?
Will I get public IPv6 addresses for all of my internal devices?
Is there a firmware I can use on either my Linksys or Asus device to do dual stack?
Cheers,
Trevor Sullivan
http://twitter.com/pcgeek86
↧