Hi, my digras as below
HQ Cisco ASA A1 (y.y.y.y) ----- internet --- u-serve (x.x.x.x/28)--- (x.x.x.x1) Cisco ASA B1 ---- LAN
what I need is to configure U-serve to pass all traffic to my B1 firewall to use IPsec S2S tunnel, I did this configuration in the U-serve NVG510 (9.0.6h2d30)
Configured Public subnet (x.x.x.x) second last IP for the public IPv4 address field, then subnet then start and end IP addresses for DHCP and I chose Public as primary DHCP pool.
then in the IP passthrough chose passthrough with DHCPS-Fixed and put my B1 MAC address, and configure my B1 IP address from the DHCP public range.
Please is that will make it work as expected? as this is a live network and when I switch it need to be minimal down time
Mike
↧