ATT Uverse Voice/Data/TV - Austin
Reworking my home network and, like some kind of dingelberry, I pulled the data line (NID to RG) before I fully examined the wiring scheme. Now I'm having all sorts of issues with Broadband 2 and can't for the life of me figure it out.
To summarize, my NID uses the blue/blue white and orange/orange white pair wired in. I know because those were jumped at the box to my house wiring (Cat 5e). I connected (crimped) those four wires to the corresponding wires on a Cat5e line that runs to my living room, connecting them to the appropriate slots on a keystone Cat6 wall jack:
- 3 = Orange
- 4 = Blue
- 5 = Blue white
- 6 = Orange white
The result is as follows:
- Broadband 1 light = solid green
- Broadband 2 light = red (will sometimes blink green, then turn red)
- Phone 1 light = green (I have one phone line with ATTU)
For the life of me I can't understand why Broadband 2 won't come back up! I cut off the crimps and trimmed back both wires at the box to ensure I have good connections, and I've done the same at the jack and still nothing. If I disconnect the orange pair Broadband 1 stays solid, which seems to imply that's my primary line, but nothing I do with the orange set fixes anything.
What am I missing here? Did I miswire something? I'm using the same 2p/4w data line from the jack to the RG that the uverse tech installed (and which worked fine before). Do I need to call Uverse and get my line reset?
Thanks in advance for any help... absolutely mystified by this one. This should not be this hard...
- Junitas
↧