Hi. I've tried to read up on the topics and well as watching some YouTube videos about backfeeding so that all the phone jacks in the house would have a dial tone, but it's unclear to me.
Below are pictures of what the NID looks like.
Outside of NID
[att=1]
Inside of NID
[att=2]
I had rewired the house for phone distribution with CAT5e wiring through a 66 block since it's using POTS, while wires to/from the NID is still CAT3. I would like to switch to UVerse Voice while keeping a dial tone across all the phone jacks.
Current setup is:
NID and house wires all connected on 66 block
single RJ11 jack near the 2701 gateway
Would this new setup work?
NID wires separated from house wires on 66 block
use original RJ11 jack for backfeed from LINE1/2 of 3600 gateway
add second RJ11 jack and connect to DATA of 3600 gateway
Do I need to disconnect the phone plug from the NID?
[att=3]
↧